Javad TRIUMPH-1, Руководство оператора

Страница: 57 / 162

Configuration
Configuring the Receiver
Configuring the External UHF Modem
57
www.javad.com
• An RTK Rover collects measurement information and accepts corrections from the RTK
Base station to compute its relative position.
• A Rover acting as a repeater to re-transmit RTK Base station measurements to other rover
receivers, extending the range of a GPS system.
To configure, manage files, or maintain the receiver, connect the receiver and a computer using
one of the following methods, and start TriVU:
• use a Bluetooth®-enabled external device (computer)
• use an RS232 cable
• use a USB cable and a computer with the JAVAD GNSS USB driver installed (available
on the JAVAD GNSS website)
TriVU is a software used to manage the various functions of your receiver. The full range of
TriVU configuration and function is outside the scope of this manual. For more information on
any of the procedures in this section or on TriVU, refer to the TriVU Software Manual available
on the JAVAD GNSS website.
TriVU configures the various parts of the receiver, saving the settings in the receiver’s memory.
These settings will be reflected when you use the MinPad.
Once you have established a connection between the receiver and the computer, you will be able
to:
• configure the receiver and its components
• send commands to the receiver
• download files from the receiver’s memory
• load a new OAF and other configuration files to a receiver
• load new firmware
The following Base and Rover configurations are recommended for the most common
applications. However, you can select configuration parameters as needed for your particular
jobsite.
Note:
Do not make other changes without consulting the TriVU Software Manual.
1. Connect the receiver and computer as described in “Connecting the Receiver and a
Computer” on page 37.