2-15
TAIKO Service Manual
© 2006 Japan Cash Machine Co., Ltd. All rights reserved.
CHAPTER
2
8
7
6
5
4
3
2
1
ON
Denomination Setting Mode (This mode is for only ID-003 (serial)/ MDB/ Pulse/
ccTalk Specification. Denomination Settings “INHIBIT”/”ACCEPT” are set by DIP
Switches (See=>2-5-2) for ID-001 Parallel Interface Specification.)
To perform the accept setting, set DIP switch Nos.1 and 6 to ON and then turn on the power to
the TAIKO unit. After the LED flashes white, set DIP switch No.1 to OFF to enter the setting
mode. Insert the denomination of banknote that you want accepted into the insertion slot. The
setting is registered if the LED remains lit light blue and the banknote is returned. Insert the next
denomination of banknote that you want accepted.
8
7
6
5
4
3
2
1
ON
Inhibit Setting
To perform the inhibit setting, set DIP switch Nos.1, 6 and 7 to ON and then turn on the power
to the TAIKO unit. After the LED flashes white, set DIP switch No.1 to OFF to enter the setting
mode. Insert the denomination of banknote that you want inhibit into the insertion slot. The setting
is registered if the LED remains lit orange and the banknote is returned. Insert the next denomina-
tion of banknote that you want inhibited.
- The accept/reject setting for banknote denominations can be confirmed with
the LED lamp. After the initial operation is performed, the LED will flash a
number of times equal to the total number of banknote denominations. Blue
indicates an accept setting and red means a reject setting.
Example: If 5, 10 and 20 euro notes are set be accepted and 50 and 100 euro notes to
be rejected, the LED will flash the corresponding 5 times aws follows: blue,
blue, blue, blue, red and red.
Accept Setting
Perform the accept/inhibit setting for the banknote denomination based on the software for your
country. The default settings are to accept all denominations.
