Janome HORIZON Memory Craft 9480 QC PROFESSIONAL, Инструкция

Страница: 44 / 164

42
(1)
Utility Stitches
Straight Stitches
Patterns U1 to U5 are straight stitches for seaming. Press
the pattern selection key for the desired stitch.
Starting to sew
Place the fabric next to the seam guide line on the needle
plate. Lower the needle to the point where you want to
start.
Pull the needle thread towards the rear and lower the
foot.
(2)
(3)
5/8˝
NOTE:
Pull the needle thread to the left when using satin
stitch foot F, open-toe satin stitch foot F2, dual feed
foot or automatic buttonhole foot R.
Press the start/stop button or foot control to start sewing.
Gently guide the fabric along the seam guide line letting
the fabric go naturally.
(1) Start/stop button
Sewing from the Edge of Thick Fabric
The black button on the zigzag foot A locks the foot in the
horizontal position.
This is helpful when you start sewing at the extreme edge
of thick fabrics or for sewing across a hem.
Lower the needle into the fabric at the point where you
wish to start sewing.
Lower the foot while pushing in the black button. The foot
is locked in the horizontal position to avoid slipping.
After a few stitches, the black button is released
automatically.
(2) Black button
Changing Sewing Direction
Stop the machine and press the presser foot lifter button
to raise the presser foot.
Pivot the fabric around the needle to change the sewing
direction as desired.
Start sewing in the new direction.
NOTE:
If you turn on the foot up option, the presser foot will
automatically go up when the machine stops (refer to
page 53).
Turning a Square Corner
To maintain a 5/8˝ seam allowance after turning a square
corner, use the cornering guide on the needle plate.
Stop sewing when the front edge of fabric reaches the
cornering guide lines.
Press the presser foot lifter button and turn the fabric 90
degrees.
Start sewing in the new direction.
(3) Cornering guide