Janome Hello Kitty 18750, Инструкция по эксплуатации, Страница: 80 / 100

74
q e w
q
r
q
e w
w
e
q
Tacking
Machine setting
q
Stitch pattern: 09
w
Needle thread tension: 3 to 6
e
Presser foot: Satin stitch foot: F
Tacking is used to reinforce pockets, crotches and belt car-
riers where extra strength is needed.
• To sew
Start the machine and sew until the machine stops
automatically. The machine will sew a tacking 5/8˝ (1.5 cm)
long.
q
5/8˝ (1.5 cm)
• To sew a shorter tack
* Set the speed control slider at low speed setting.
To sew a tack shorter than 5/8˝ (1.5 cm), first stop the
machine at the end of required length
w
, then press the
reverse stitch button
e
.
The tack length
r
has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
w
Required length
e
Reverse stitch button
r
Tack length
t
Starting point
• To sew a same-sized tack
Simply start the machine to sew another tack at the same
size.
Eyelet
Machine setting
q
Stitch pattern: 49
w
Needle thread tension: 1 to 4
e
Presser foot: Satin stitch foot: F
The eyelet is used for belt holes etc.
• To sew
Attach the satin stitch foot F.
Start the machine. The machine will stop
automatically when completed.
Open the eyelet with an awl, eyelet punch or pointed
scissors.
• To adjust the shape of an eyelet
Correct the shape of the eyelet as follows:
Press the cursor buttons to move the cursor under
the value “L3” (default setting)
q
.
If the eylet gap opens
w
, press the button to make the
darn even. (L1 – L2)
If the eylet overlaps
e
, press button to make the darn
even. (L4 – L5)
NOTE:
The shape can be adjusted within L1 to L5 (default
setting is L3).
t
w
r
e