Jands HUB 24, Руководство по эксплуатации

Страница: 24 / 46

18 Dimmer Operation
Operating Manual HUB24 Series Dimmer
4.2.30 Playback a Chase (7-2)
Menu 7 Playback 7-2 Chase
When playing back a chase, it can be assigned control of all dimmer outputs or a
selection of dimmer outputs. Channels in the chase that have not been assigned an
output will be ignored.
•
Select “7-2 Chase” on the menu.
•
Turn the encoder wheel to highlight the chase to playback.
•
Press SELECT.
•
Turn the encoder wheel to highlight “All” or a single dimmer output.
•
Press SELECT.
•
If “All” was not selected, turn the encoder wheel and select other dimmer outputs
that need to be assigned to this chase.
Use “6-2-#-2 Parameters” in Record Chase to adjust the way a chase is playing
back. These parameters are level, speed and crossfade.
4.2.31 Clear Playback (7-3)
Menu 7 Playback 7-3 Clear Playback
Clear Playback stops the playing back of all snapshots and chases, returning those
dimmer outputs to solely DMX control. It can be applied to all dimmer outputs or a
selection of dimmer outputs.
•
Select “7-3 Clear Playback” on the menu.
•
Turn the encoder wheel to highlight “All” or a single dimmer output.
•
Press SELECT to restore output(s) to DMX control.
•
If “All” was not selected, turn the encoder wheel and select other dimmer outputs.
4.3 Deep clear
In the event of a software “lockup” or error message (see section 5.3), the HUB24
dimmers have a facility that enables them to be Deep Cleared.
CAUTION
THIS FUNCTION WILL ERASE THE ENTIRE MEMORY SETTINGS.
•
Hold down both buttons while turning power ON to the HUB24.
•
The display will show “Deep Clear”.
•
Press CONFIRM to confirm deep clear.
•
The normal main screen will be shown when deep clear is finished.
Note: It may be necessary to adjust the LCD contrast.