XG100WM User Manual
2-4
Janam Technologies LLC
Install the Battery
IMPORTANT Battery Warning!
CAUTION: Use only Janam-approved batteries.
There is the risk of explosion if battery is replaced by an incorrect type.
Always dispose of used batteries according to the instructions.
INSTALLING THE BATTERY:
1. Insert the top of battery into chamber opening and gently slide battery into battery chamber.
Do not force past point of resistance.
2. Turn the battery so that the base of the battery is perpendicular to the device handle.
This aligns the battery notches with the battery chamber which is required to insert the battery. Once the
battery is properly aligned with the handle, press the battery into the battery chamber.
3. Turn the battery base clockwise until the base of the battery is parallel with the device. The battery release
plunger will click and lock the battery into place.
REMOVING THE BATTERY:
1.
To remove the battery, fully press the battery release plunger and hold while rotating the battery counter-
clockwise until it stops (battery base will be perpendicular to device handle).
2.
Grip the battery base and pull battery from battery chamber.
CHARGING THE BATTERY:
Important Note: The backup battery must charge at a low current. Initial charge-time for the backup
battery, therefore, is 72-hours. During this period, even though the main battery may indicate full charge,
the device cannot maintain any user data if the main battery is removed. The initial 72-hour charge-time for
the backup battery is required prior to first use or after a full drain of the backup battery.
Full drain of the backup battery will occur when:
▪
The main battery is removed and the device uses the backup battery to sustain its last state of operation for
15 minutes or more.
▪
The main battery’s charge drops below 7% (the backup battery will support continued function for up to 15
minutes).
