GB
19
•
For ease of assembly only loosely tighten bolts and
then tighten fully when assembly is complete.
•
Do not over tighten bolts; only tighten with moderate
pressure to avoid damaging the bolts or compo-
nents of the BBQ Grill.
•
Ensure that the lid is closed prior to assembly.
Assembly instructions
– Position the parts on a flat surface that will not
scratch the finish of the nest components, paying
close attention to the joint overlap in illustration the
2pcs Upper cross brace (4 & 5) and 2pcs Lower
cross brace (2 & 3). Using the given hardware and
hand tighten the braces with screw (A) + nut (E).
– Stand the section (1) upright, and place the upper
cross braces (4 & 5) close to section (1). Inserting
truss head screw (C) through the hole of section (1)
and section (4 & 5) and install (F) Keps nut and
tighten securely.
– Place the assembled lower cross braces (2 & 3)
under section (1), Stand the section (6) upright to
make it close to section (1) and secrion (4 & 5).
Inserting screw (B) through section (4 & 5) and sec-
tion (6), install (F) Keps nut and tighten securely.
Next insert the threaded caster stem through the
hole in the end of the lower cross brace then through
the riser and finally the riser brace.
– Install (I) flat washer and (G) Keps nut, repeat this at
the remaining (3) caster locations and securely
tighten.
– As picture, put wheels (7) in front, and wheels with
brake at the back.
– To place the Oven on the cart first remove all of the
items that are inside of the grill to make lifting easier.
– Use a minimum of two people when lifting the Oven
onto the cart. Place one of your hands in the bottom
vent of the Oven and the other under the grill. Lifting
by the hinge or the side tables could result in injury
and damage to the product.
– Position the nest upright on a flat level surface with
the help of an assistant you can now place the oven
into the nest. Position the oven so the vent door is
accessible between two of the risers and gently
push downward on the oven to seat it in the nest.
– When the grill is securely placed on the cart add the
firebox (11), charcoal plate (10), upper ring (9) and
cooking grill (13) inside of the BBQ Grill as displayed
in the assembly diagram.
– Press down on the castor levers (7) to lock the cas-
tor wheels to ensure the BBQ can not move when in
use.
– To attach the handle (14) to the lid of the BBQ Grill
(12) start by attaching 4× handle brackets using the
4× pre-attached bolts and dome headed nuts.
– To attach the top vent (15) to the BBQ Grill (12)
place it on top and align both the bolt holes. Secure
using 2× bolts (D) and nuts (H).
– Attach the 2× table brackets (17) to the BBQ Grill
(12) using the 4× pre-attached bolts and dome
headed nuts per bracket. Please note the position
shown in the above diagram.
– Attach the 2× table brackets (18) to the BBQ Grill
(12) using the 4× pre-attached bolts and dome
headed nuts per bracket. Please note the position
shown in the above diagram.
– Insert the 2× table hinge (16) into each of the table
brackets (17 & 18).
– After set-up, check all connections.
•
The Grill is now ready to use but please ensure that
you have read the curing instructions thoroughly
prior to use.
•
Disassembly is in reverse order.
Operation
Extinguishing
– To extinguish unit - stop adding fuel and close all the
vents and the lid to allow the fire to die natuarally.
– Do not use water to extinguish the charcoals as this
could damage the ceramic BBQ.
Curing the BBQ
– To start a fire, place rolled up newspaper with some
lighter cubes or solid firelighters on the charcoal
plate (10) in the base of the Ceramic BBQ. Then
place 2 or 3 handfuls of lump charcoal over the top
of the newspaper.
– Open the bottom vent and light the newpaper using
a long nosed lighter or safety matches.
– Do not overload the unit with fuel – if the fire is too
intense this could damage the Ceramic BBQ.
– Leave until all the fuel is used and extinguished.
– If the first burns are too high it could damage the felt
gasket seal before it has had the chance to mature
properly.
Note:
Ensure that the top vent bolt is on the left
hand side when assembling it.
DANGER! Risk of explosion!
Do not use
spirit, petrol or similar liquids to light or re-light
the BBQ!
Only use lighters in accordance with EN 1860-
3!
DANGER! Danger of fire!
This BBQ grill
becomes very hot and may not be moved
when in use!
Keep away from children and animals!
Do not used in closed rooms!
WARNING! Fire risk!
Grip grill handles only
with gloves!
Always wear gloves when adjusting the height
of the grilling rack as the handles of the rack
can become very hot during grilling.
Note:
The fire basin can accommodate a max-
imum of around 0,7 kg of ordinary charcoal.
Note:
On the rim of the BBQ body and lid, a
black felt gasket is applied to increase the air-
tightness of the rim. This black felt gasket
should not be removed, but has to stay in posi-
tion during use.
Содержание Marwin L
