TM/TMC/RM/RMC-9730CL
8
Installation
Table 4
12P-02S Interface Cable
12P-02S Interface Cable
Pin# Lead
Color
Function
Pin#
Lead Color
Function
1 Gray GND
7
Black coax
VD Input
2 Yellow
+12V
DC
8
White coax shield
Reserved
3
Red coax shield
GND
9
White coax
HD Input
4 Red
coax
Video
10
Brown
NC / Y Output*
5
Orange coax shield GND
11
Blue
NC
6 Orange
coax NC
12
Black coax shield
NC / C Output*
Note: Make sure that the unused leads are not touching and that there is no possibility that exposed
wires could cause the leads to short.
* Option OP27-3, NTSC Y/C output.
2.2.4 (c) Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 4. Connect the Ground lead to pin
#1, and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of
sufficient current to properly power the camera.
2.2.4 (d) Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to
properly attach the power cable to the camera connector:
1.
Rotate the connector while applying slight pressure until the keyways line up.
2.
Press the connector into place until firmly seated.
3.
Plug the power cord into the AC socket. This will power the camera up.
2.2.5
Attaching the Analog Video Output
When connecting the TM-9730CL to an analog frame grabber or a multisync monitor, use the BNC
connector on the rear panel of the camera. The input of the monitor should be balanced for 75
Ω
termination. Standard RG-59 type coaxial cable should carry a full video signal for up to 100 feet.
The multi-conductor cable 12P-02S from JAI Inc. can be used to transmit analog video, power, sync.
signals, and serial communication. The mini coaxial leads in JAI Inc. multi-conductor cables are
designed for short runs of no longer than 100 feet.
Note: Make sure that no extraneous wires are visible which could cause a short.
2.2.6
Attaching the Camera Lens
The TM-9730CL camera accepts 2/3" or larger format size C-mount lenses. To attach the C-mount
lens to the camera, carefully engage the threads and rotate the lens clockwise until it firmly seats
on the mounting ring. Do not force the lens if it does not seat properly. Please note that some
lenses with extremely long flangebacks may exceed the mounting depth of the camera.
Содержание TM-9730CL
