Pure Air
®
Bath
Page 16
www.jacuzzi.com
Installation and Operation
English
Drain Assist Purge
The purge cycle is automatic and will reduce excessive accumulation of residual water in the air channels.
There are two purge cycles, drain assisted purge and daily purge.
The purge cycle is sensor assisted – two sensors (metal dials) are located near the drain of the bathtub. The sensors
detect the presence and absence of water in the bathtub.
To ensure effective and correct operation of the water sensors, it is important to keep them clean and free from
blockage or objects.
After bathing and following the emptying of the bathing well, the sensors detect a “no water” condition. A five minute
wait time elapses and then the blower is activated. The blower will cycle through a range of speeds for 2 ½ minutes,
during which either 2 or 3 indicator lights will flash at various speeds.
•
The purge cycle will engage even if the blower is not used during bathing.
•
The cycle may initiate more than once if the sensors become wet during any part of the purge operation or during
routine cleaning of the bathtub. This is normal and does not require attention.
Purging Air Channels
Chromatherapy (Light) Operation
Press light button 1st time:
Turns colored lighting ON, use up and down buttons to start
color scroll or select alternate color.
Press light button 2nd time:
Turns white lighting ON, use up and down buttons to select
intensity of white light.
Press light button 3rd time:
Turns all lighting OFF
Colored Lighting Operation
The colored lighting default is constant blue. Pressing the (+) button activates color scroll in this order: blue, teal,
green, yellow, orange, red, pink, purple and then returns to blue and continuously repeats. To stop on a selected color,
press the (+) button again. Pressing the (-) button activates color scroll in this order: blue, purple, pink, red, orange,
yellow, green, teal and then returns to blue and continuously repeats. To stop on a selected color, press the (-) button
again.
White Lighting Operation
There are five white light intensities. Press the (+) button to increase light intensity. Press the (-) button to decrease
light intensity.
Each day, the blower will automatically activate a daily purge. The blower will operate for one minute on high power,
followed by 15 seconds at ½ power.
To set purge time:
Wait until the time which you desire the daily purge to activate, with the blower off, press and hold the plus button for
five seconds. To confirm that you have set the time, the blower will cycle between on and off 2 times in a 4 second
span.
To cancel daily purge:
With the blower off, press and hold the plus button for five seconds. To confirm that you have cancelled the purge, the
blower will come on for 1 second and then stop.
YOU MUST SET THE DAILY PURGE UPON INSTALLATION; THE DEFAULT IS NO PRE-SET DAILY PURGE.
If a power failure occurs, the system will default to no daily purge cycle.
Daily Purge
