11
INSTALLATION MANUAL
3 Yellow
1 Red
2 Black
4 Green
Red 4-Pin Terminal Bar
Figure 5.
rS-485 WiriNg
NOTE:
Wire only two (2) devices (e.g, the iAquaLink
®
and one additional device) to the RS-485 con-
nector. If you have more than one additional
device in your equipment configuration, use a
multiplex board.
INSTALL JANDY VALVE
®
ACTUATORS (JVAS)
(IF APPLICABLE)
You may wire up to three JVAs on the JAUTPS/JAUTP.
Two (2) JVAs are included in JAUTPS (Pool/Spa combo).
An additional JVA may be required on a pool/spa
combination configuration to control a water feature
or solar panel, for example.
NOTE:
Read and follow complete installation intruc-
tions and safety information in the Jandy Valve
Actuator owner’s manual (included in the JVA
packaging).
3.
Install intake JVA and return JVA on equipment lines
according to installation instructions in the owner’s
manual.
4.
Feed intake JVA wire through the black low voltage
wiring knockout.
5.
Plug JVAs in as shown in Figure 2. Wiring Diagram.
6.
Feed return JVA wire through the black low voltage
wiring knockout.
7.
Plug return JCA connection into the center socket.
SECTION 6. SECTION SYSTEM
SETUP, PROGRAMMING AND
TESTING
All system programming and installation setup is
performed through the JAUTPS/JAUTP user interface
UI.
NOTE:
For a complete list of all menu commands and
functions, refer to the Owner’s Manual.
Select
Back
More
Back Button
Power Light
Select Button
Alert Light
Power Button
Menu Screen
Up/Down (Scroll)
Arrows
Power
Alert
12:40PM
Pool Mode
Off
Pool Heater 74°F
Spa Mode
Off
Spa Heater
Off
Settings >
Devices >
Service Mode
>
Figure 6.
uSer iNTerFACe
