6
JAUTP / JAUTPS CONTROLLER
2.3
MATERIALS AND TOOLS
Installation Materials Furnished
• Screw Set (includes Plastic Anchors)
• Metal Mounting Bracket
Tools Needed for Installation
• Power Drill
• 3/16” Drill Bit - Hammer Drill Bit (only necessary to drill into brick or concrete)
• Conduit Fittings
• Wire Nuts
• Wire Crimping Pliers
• Pencil or Marking Pen
• Flat Head Screwdriver
• Phillips Head Screwdriver
• Small Flathead or Slotted Screwdriver
• Protective Safety Eyewear
• Protective Work Gloves
SECTION 3.
INSTALL CONTROLLER BOX
WARNING
FOR YOUR SAFETY:
This product must be
serviced by a professional pool/spa service
technician as described on the front cover of this
manual. The procedures in this manual must be
followed exactly. Failure to follow warning notices
and instructions may result in property damage,
serious injury, or death. Improper installation and/or
operation will void the warranty.
When mounting the controller box in the equipment
pad, instructions must be followed exactly. Read
through the Important Safety Information section
completely before beginning installation and before
operating the equipment.
Before you begin installation, make sure you have the
necessary tools and a suitable location to install the
JAUTPS/JAUTP.
NOTE:
The controller should be located at or near
the equipment pad.
Locate the controller at least five (5) feet or more
away from pool/spa and five (5) feet off the ground. All
national, state, and local codes are applicable.
3.1
MOUNT THE CONTROLLER
ENCLOSURE
1.
Using a flat screwdriver, rotate door tumblers counter-
clockwise to unlock the front cover of the controller.
2.
Open the front cover door and remove the mounting
hardware kit.
3.
Using the holes in the bracket as a guide, mark four
(4) dots on the surface where the controller will be
mounted. The four (4) mounting holes are 3-15/16” (10
cm) apart center to center.
NOTE:
Make sure to mark out the four (4) holes as
accurately as possible.
4.
Drill four (4) holes in the mounting surface.
5.
Press the four (4) plastic anchors firmly into holes.
6.
Screw the mounting bracket onto the mounting surface
with the four (4) screws provided.
