OPERATION 5
en-29
5.5
STOPPING / PARKING ______________________________________________________
To stop:
Remove your foot from traction pedal to slow the mower
speed. The mower will automatically brake when the
traction pedal returns to Neutral.
To park the mower under normal conditions:
1.
Disengage the PTO switch, raise the decks, engage
transport latches, and move away from the area of
operation.
2.
Select a flat and level area to park.
a.
Release traction pedal to bring the mower to a
complete stop.
b.
Disengage all drives, disengage transport
latches, lower decks to the ground, reduce throt-
tle to slow, and allow engine to operate at no
load for a minute.
3.
Engage parking brake, stop the engine, and always
remove the ignition key.
If an emergency arises and the mower must be parked in
the area of operation, follow the guidelines outlined by
the grounds superintendent. If the mower is parked on an
incline, chock or block the wheels.
5.6
TO DRIVE / TRANSPORT ____________________________________________________
Read and follow all safety notes contained in this manual
when driving or transporting mower. Refer to
Section 5.3
for general operating instructions. When operating in
reverse look behind you to ensure you have a clear path.
Important:
If this mower is driven on public roads, it must
comply with federal, state, and local ordinances. Contact
local authorities for regulations and equipment
requirements.
1.
Disengage all drives and raise implements to the
transport position and engage transport latches when
driving to and from the area of operation.
2.
Shift mower to 2WD.
3.
Disengage parking brake and move throttle lever to
FAST. Depress traction pedal slowly.
4.
Always bring the mower to a complete stop before
changing travel direction or shifting from 2WD to
4WD.
5.7
TRANSPORT LATCHES _____________________________________________________
1.
The wing decks are equipped with a latch to prevent
accidental lowering of the cutting units during
transport or maintenance operations. The latch
knobs are located on the engine fire wall, behind and
to the left and right of the operator’s seat.
2.
Fully raise the wing decks and push the latch knobs
in to secure the deck. The weight of the deck/lift arm
must not rest on the latch.
3.
To release latch, pull the latch knob out and lower
the deck to the ground.
NOTICE
Permanent damage to the turbocharger may occur if
the engine is shut down without allowing the
turbocharger time to cool.
To prevent damage, operate the engine with no load
and at half throttle for 3 to 5 minutes before shutting
off engine.
CAUTION
To prevent injury to bystanders, or damage to the
equipment, do not rest the weight of the deck and lift
arm on the latch. Weight of deck and lift arm may
cause the deck to fall when the latch is released.
!
NOTICE
Do not transport with the arms resting on the latch.
Transport latches are only used to prevent accidental
lowering of the cutting units.
Содержание R311T-T4I
Страница 63: ...NOTES 11 en 63 11 NOTES ...
Страница 125: ...REMARQUES 12 fr 63 12 REMARQUES ...
