Jacobsen R311T-T4I, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 28 / 126

5 OPERATION
en-28
5.4 STARTING _______________________________________________________________
1. Make sure fuel shut off valve is completely open and
the tow valve (
See Section 5.10 ) is closed.
2. Sit in operator’s seat, make sure the PTO switch
(M) is OFF, traction pedal is in Neutral, cruise
control switch (S) is OFF, and the parking brake
switch (N) is ON.
3. Move throttle lever (L) between 1/4 to 1/3 throttle.
Turn ignition switch (T) to RUN.
4. Press glow plug switch (U) for about 3 to 7 seconds.
The colder the temperature, the longer it will take to
energize plugs. Do not press switch for more than 7
seconds. Energizing glow plugs is not necessary
when starting a warm engine.
5. Turn ignition switch (T) to START position. Release
switch as soon as engine starts. Do not hold key in
start position for more than 15 seconds at a time. If
engine does not start, turn ignition switch off, wait
30 seconds, and try again.
6. Allow the engine to become warm and properly
lubricated before operating at high RPM.
Figure 5A
CAUTION
IMPORTANT: Do not use starting assist fluids. Use
of such fluids in the air intake system may be
potentially explosive or cause a “Runaway” engine
condition and could result in serious engine damage.
NOTICE
Allow engine to operate at low idle for at least one
minute before operating mower.
When starting engine at temperatures below 40° F (4°
C), operate the engine at low idle for five minutes to
prevent damage to engine or hydraulic system.
!
J-T T
XXXXXX
X
X
X
X
X-X-
X
X
77
93
° C
170
200
° F
10
16
12
14
VO
LT
S
SOLID
ST
A
T
E
HOURS
0000
0
10
10
10
30
30
10
10
10
10
30
30
10
L
U
M
T
S
N
P