Maintenance Manual for J2 Sedan
Service
20
■
In case any component is found damaged,
repair or replace.
2. Inspection of Clutch Fluid Level and Leakage
If the fluid level is low, check clutch system for any leakage.
3. Inspection of Clutch System
Check for correct installation positions of liquid pipelines and operation cylinders, and any crack,
damage, loose connection, worn or ageing.
4. Inspection of Manual Transmission Gear Oil
Inspect oil level and whether there is any leakage. For detailed information, refer to “Inspection of
Manual Transmission Oil”.
5. Change Manual Transmission Gear Oil
1) Thoroughly drain oil from drain plug, and then refill with new gear oil. For detailed information, refer
to “Change Manual Transmission Oil”.
2) Inspect oil level. For detailed information, refer to “Inspection of Manual Transmission Oil Level”.
6. Wheel Balance
1) Dismantlement
①
Dismount the wheel(s) need to be adjusted.
②
Dismount the old balance blocks from both sides of the wheel, clear any foreign matters from treads
of tyre.
Note: for new tyre(s), the tape on the tyre should be removed.
Attention:
■
During dismantlement, be careful not to scratch the tyre.
2) Adjusting wheel balance
①
Take the center hole as guide to install the wheel on balancer. Start the balancer.
②
When unbalance values of both inner side and outer side of tyre have been indicated on the display
of wheel balancer, multiply the unbalance value of outer side with 5/3, so as to define the weight of
balance blocks which will be actually applied. Then, select the outer side balance block of which
Fig. 2.2.009
