jablotron JA-60GSM, Руководство пользователя

Страница: 4 / 12

User manual JA-60GSM - 4 - MFJ51808
- 4 - MFJ51006
1.10. Alarm system remote control via a telephone keypad
If you want to operate the alarm system via a phone (mobile or landline), perform the following:

Dial the GSM dialer number. An attached telephone will ring.

If the phone is not answered the system will answer in 25 seconds - indicated by a short beep.

Enter the remote access code; factory default is 1111; to change this code see section 4.1.

Confirmation sounds indicate the control panel mode: 1 beep = armed, 2 beeps = disarmed, 3 beeps
= programming mode, Siren sound = alarm.

From this moment the telephone keypad will work as the alarm control panel keypad. Key E is
interpreted as F, key # as N.

To terminate the connection simply hang up. Connection will automatically terminate if there is no
entry within 60 seconds.
Notes:

Remote access from a landline is only possible from a phone using tone dialing (DTMF)

It is impossible to operate the system remotely without a valid remote access code (if used).
1.11. Remote controlling of an appliance via a telephone keypad
If you want to operate outputs PgX or PgY (e.g. an appliance in the house) from a phone (mobile or
landline), perform the following:
a) Dial the GSM dialer number. An attached telephone will ring.
b) If the phone is not answered, the system will answer in 25 seconds - indicated by a short
beep.
c) Enter the remote user access code; factory default setting is 1111; to change this code see
section 4.1.
d) The system will confirm the validity of the code with a beep.
e) From this moment you can operate the PgX and PgY outputs by entering:
 
80 - to switch off
 
81 - to switch on (permanently)
f) To terminate the connection simply hang up. Connection will automatically terminate if there
is no entry within 60 seconds.
Notes:

Remote access from a land line is only possible from a phone using tone dialing (DTMF)

If the system is programmed to allow control only with a valid code the control sequence must
be complete with a user code: (

8[code]0 or

8[code]1).

For using this function the alarm system must support F 81 and F 80 sequences
1.12. Remote voice communication with premises
If the SP-01 intercom is plug-in to the PHONE terminal (it must not be combined with any phone
connected) it is possible to create a one way (talking or listening) communication from an authorized
(stored) phone numbers (see 2.1.). Procedure:
a) From an authorized phone dial the JA-60GSM phone number. The SP-01 will ring once and
then it will answer the call
b) Potential alarm on the control panel will be terminated
c) You can talk to the premises
d) For switching to the listening mode press 5 on your phone. For switching back to the talking
mode press key 2. Or by pressing button 1 it is possible to toggle between talking and
listening.
e) Press 0 or hang-up to terminate the call.
Note:

Only a phone with available DTMF can be used.