IWILL P55XB2, Руководство пользователя, Страница: 15 / 91

15
Sub male connector cable are for Serial port, one 26 pin convert to 25 pin D-
Sub female connector cable is for Parallel port, one 5 pin housing but 4 wires
into a 6 pin Mini-DIN is for the PS/2 mouse.
Step 8. Connect the SMI
(System Management Interrupt)
Switch
Some computer chassis provides a SMI switch from front pannel, connect this
2 pin wire to this SMI switch(any direction can function this). This will force
the system into a Suspend mode/ Green, to decrease electricity and longer life
of component that not in use. Or the user can use chassis that still provides the
Turbo switch and functionless on current motherboard.
Once the SMI switch was pushed, this will force the system into the “suspend
mode” immediately. Any key strike on the keyboard will wake system up.
PCI
RST
IDE
SMI
LED
SPEAKER
KEYLOCK
1
1
1
Step 9. Connect the Reset switch
Most computer chassis provides a reset switch to front pannel control, this will
reboot the system without turn off and on the power switch while the reset
switch was pushed. Use the chassis provides a 2 pin housing and connect to
this reset switch (any direction can function this).
Step 10. Connect the Keylock
(keyboard lock)
Switch
Most computer chassis will provides a keylock switch. Normally, connect the
marked keylock connector to this motherboard’s keylock connector. This will
cause the keyboard out of function once you switch the keylock to “Lock”.
This will prevent any un-authorized keyin. The onboard keylock connector
was a 5 pin pin-header, connect to the right side two pin will function this.
(Reference to the Chapter 3—Hardware Installation for detail pin assignment)