12
Canister cannot be
installed
Remedy
1
2
3
4
11
12
Difficult to ignite
Remedy
4
5
6
7
8
9
Cannot ignite
Remedy
5
6
7
8
9
10
11
12
13
15
16
Burner would not stay lit
Remedy
5
7
10
Flames around the
electrode is red
Remedy
17
Burns with a yellow
flame
Remedy
7
10
Flame is unstable
Remedy
7
10
Flame is irregular
Remedy
7
Heating power is low
Remedy
5
7
10
14
There is a gas odor
Remedy
4
8
9
12
Flame goes out during
use
Remedy
5
10
11
Flame does not go out
Remedy
9
Gas leaks even when the
ON/OFF knob is “OFF”
Remedy
4
9
12
A popping sound occurs
during extinguishing
Remedy
18
Flames burn away
from the burner
Remedy
19
Troubleshooting
In the event of an unexpected malfunction, troubleshoot by
using the following information.
Issue
Remedy
Cause
Solution
FS01
21,00
1
Is there any deformation or
warping on the main unit?
Request an inspection and repair.
2
Have iron scraps or powder
adhered to the magnet?
Remove the iron scraps or powder using
adhesive tape.
3
Is the ON/OFF knob set to “ON”?
Set the ON/OFF knob to “OFF”.
4
Is a canister made by another
company being used?
Use a dedicated Iwatani canister.
5
Has the gas run out?
Is there little gas remaining?
Replace with a new canister.
6
Have stains or moisture stuck
to the electrode section?
Wipe away the stains or moisture.
7
Is the burner flame opening
clogged?
Use a metal brush or other similar item to
remove the clog.
8
Is the ignition operation
being performed correctly?
Perform the ignition operation correctly.
(page 6)
9
The ON/OFF knob may have
failed.
Request an inspection and repair.
10
The gas duct (nozzle) may
be clogged.
Request an inspection and repair.
11
Has the pressure sensor
safety device been activated?
Reset the device following “● When the
pressure sensor safety device has been
activated” (page 3).
12
Is the canister installed
correctly?
Install the canister correctly. (page 5)
13
The ignition device may
have failed.
Request an inspection and repair.
14
Is the ON/OFF knob opened
fully?
Open the ON/OFF knob fully.
15
Is the spark jumping from
the electrode to the burner?
When the spark is not jumping from the
electrode to the burner, adjust so that the
distance between the electrode tip and burner is
about 3 mm, and the flame opening is centered.
16
Is the spark jumping?
If the spark is not jumping, stains or water
drops have stuck to the white section of
the electrode (ceramic). Wipe away the
stains or moisture.
17
The flame around the electrode is red during the first use after purchase.
After several uses, the red flame disappears. Continue to use the product as is.
18
A sound during extinguishing is not a problem. Continue to use the product as is.
19
This is not a problem. Turn down the ON/OFF knob slightly for 2 to 3 minutes.
