6
Ignition, adjusting the heating power, and extinguishing the flame
Ignition
Adjusting the heating power
Extinguishing
Turn the ON/OFF knob in the
“ON” direction until it clicks.
Make sure the flame was lit.
Low
High
Turning the ON/OFF
knob in the “ON”
direction increases
the heating power,
while turning in the
“OFF” direction
decreases it.
Turn the ON/OFF
knob in the “OFF”
direction until it
stops.
● If there is no flame, return the ON/OFF knob to the
“OFF” position, and then try again.
It may be difficult to light the product upon first use
or when the temperature of the canister is low.
With caution, repeat the ignition operation several
times.
● If an ignition operation is performed too quickly, the
gas may not spread sufficiently within the burner,
which makes ignition more difficult.
● When using low heat, always check the flame
as it is difficult to see.
● Be aware that if the flame is lowered too
much, it is more likely to be extinguished by
wind.
After use (steps after extinguishing the flame)
Make sure the flame is out completely
● Just after the flame is extinguished, both the main
unit and the canister will be hot.
Wait until they cool down.
Remove the canister (below)
● Always remove the canister.
Otherwise, appliance failures or
gas leaks may occur.
Ignite a flame after the canister has
been removed
● A small amount of gas remains in the
piping of the main unit. To prevent danger,
perform ignition one time to burn off the
remaining gas.
Advice
When ignition is difficult, light a firing rod (gas lighter, etc.), and
then ignite the burner head while turning the ON/OFF knob in
the "ON" direction.
● It may not be possible to light the ignition device depending
on the weather or elevation. Please prepare a firing rod (gas
lighter) or other similar equipment as a backup ignition source.
Firing rod (gas lighter)
Removing the canister after use
After use, always remove the canister, put on the canister cap,
and then store the canister.
Open the canister cover.
While holding the canister, apply a small amount of force in the direction
opposite the installation direction to remove it from the magnet.
Put the canister cap on the removed canister.
Close the canister cover.
