41
O
pe
ra
tion
Menu screen
Push the MENU key in the MAN/EXT selection mode and call up the menu screen. Use the right and left keys
to scroll through each menu item and then push the Enter key to make a selection. Pushing the MENU key
again or ESC key in the menu screen, the previous mode will be recalled.
EXT mode selection
The pump can run in four different operating modes of Analogue,
Pulse, Batch and Interval Batch for the external signal. See page
14-18 and 42 for detail.
Calibration
Calibrate the pump to obtain a correct flow rate on the screen.
See page 37 and 44.
Signal input setting
Program STOP, Pre-STOP, Interlock functions and diaphragm
rupture detection. See page 18-21, 45 and 46.
Analog output setting
Set the output current at SP1 and 2 flow rates to configure the
analog signal output behaviour. See page 46.
Alarm output setting (OUT 1)
Enable or disable the output of the batch completion, STOP,
Pre-STOP, interlock, diaphragm rupture detection, overload/failed
speed detection, and/or drive error detection functions. See page
21 and 47.
Alarm output setting (OUT 2)
Enable or disable the output of the batch completion, STOP,
Pre-STOP, interlock, diaphragm rupture detection, overload/failed
speed detection, drive error detection, and/or volume proportional
pulse functions. See page 21 and 49.
Data logging
The pump can display operating time, total flow volume, power-on
time, the number of ON/OFF and software version. See page 50.
Programming of other functions
Program a suction speed, a max flow rate, an AUX speed, a dia
-
phragm position, an anti-chattering time, butter ON/OFF, output
logics, a flow rate unit and your language or so. See page 21, 51,
52 and 53.
Operation programming
