IVT GP-800, Инструкция по эксплуатации и безопасности, Страница: 6 / 36

6
Manual instruction | Auto garden jet pump
EN
protection functioned correctly (the unit stopped
operating). When you press button (3) again,
pumping-in process will be restarted. If button (3) is
pressed 5 times then the unit is turned off, and the
red indicator will blink. Then, it is necessary to stop
the unit and fix the trouble.
Operation order
Attach hoses as described above •
Submerge the water exhaust hose into the basin •
that must be located below the level of the pump.
Suspend the water exhaust hose: this will •
prevent the machine from slipping down, as the
hose weight will be taken by the suspension, not by
the machine.
Turn off the pumping-in socket stopper (5) and •
fill the unit out with water
Make sure that the air is ousted by the liquid OK. •
Turn the unit on. •
Press button (10) (yellow indicator). If during 3 •
minutes the unit doesn’t start pumping in (due to
air, obstruction, too big pumping-out height, or too
long hose), then the unit will turn off automatically
(red indicator on, yellow indicator off). In this case
try to restart the pumping in process using button
(3).
Put the pumping-in socket stopper (5) back. •
Finishing the operation
Turn the unit off. Remove the plug off the plug •
socket.
Turn off the sink socket (9) stopper (8) and also •
pumping-in socket (6) stopper (5). This is necessary
to lower inside pressure, also it allows to pour water
off the pump.
Turn off connective sockets of pressure and •
suction hoses, and cut off the hoses.
Transportation
Transportation of the unit is done using the
appropriate handle.
Maintenance works
Before performing maintenance or toot
replacement unplug the power cord
and disconnect the device’s water
supply.
Instruction: Regularly performing the following
tasks will ensure long and reliable device operation.
Inspect the device on a regular basis in order to •
detect any visible damage, e.g., loose connections,
and worn or faulty parts.
Check the functioning and proper installation •
of guards and safety equipment. Perform any
required maintenance or repairs before operating
the device.
Storage
The device’s exterior surfaces should be cleaned with
a soft brush and cloth. Do not use water, solvents
or polishing compounds. Carefully remove all dirt
espe cially from the electric motor’s air vents.
Frost can cause damage to the device
that that has not been fully drained. The
device should be stored in a frost-free
environment.
Troubleshooting
The list below offers troubleshooting
recommendations.
Caution: Before troubleshooting switch
the device Off and unplug the cable.
The pump is functioning but doesn’t pump water
The unit is not filled with water before the start •
►
Fill the unit out with water be fore the start
The hose too high over water • ► Decrease the
hose’s position over water
Suction hose damaged • ► Check the hose for
permeability and tighten the connection area
Machine sucks in air • ► It is necessary to check,
wheth er the hose end is submerged into the fluid
and whether the level of the fluid is sufficient
The hose is functioning but the volume of water
and pressure are not sufficient
Suction hose, filter element or back valve is •
clogged up fully or partially
►
Check the condition
of the hose, filter element and valve. Clean if
necessary.
Suction hose is obstructed fully or partially • ►
Check the condition of the hose.
Too big pressure losses in he hose • ► Check the
internal diameter of the hoses. Check the hoses for
grease.
Too big height for liquid suc tion •
►
Decrease the
liquid suction height.
If the problem cannot be remedied on the basis
of the information above, please contacts local
repair shop.