Programming phone numbers:
The APD-T01 allows you to program up to nine phone numbers into the unit to be dialed when one of the
trigger inputs is activated. Note that this sequence does not select which phone numbers are dialed; it simply lets
you set up the “phone book”, as it were, of numbers which can be dialed. Selecting which numbers are actually
dialed when a particular trigger is activated will be done in a following section.
1. Key in the four-digit password
[x][x][x][x]
.
2. Press
[PROGRAM][3][ENTER]
to select “
phone number programming
” mode.
3. Press a number from 1 to 9 and press
[ENTER]
to select which of the 9 phone-number presets you wish
to program.
4. Now key in the phone number to be dialed. Each phone number can be up to 32 digits long. If you make
a mistake, use the
[DELETE]
key to back up and re-type the number.
5. Press
[ENTER]
to save the number, then
[ESC]
to exit programming mode.
Repeat this process as needed until you have entered all of the numbers (up to a maximum of 9) which you
want to the autodialer to be able to call once it has been triggered.
Deleting already-programmed phone numbers:
To erase a previously-programmed phone number, use the following sequence:
1. Key in the four-digit password
[x][x][x][x]
.
2. Press
[PROGRAM][3][ENTER]
to select “
phone number programming
” mode.
3. Press a number from 1 to 9 and press
[ENTER]
to select which of the 9 phone-number presets you wish
to erase.
4. Press
[ESC]
to blank the number and exit programming mode.
Note that the APD-T01 has no provision for editing a number once it is in place (to correct a typo, for
example); if you make an error while entering the number, and don’t catch the error until after you’ve saved it as
above, you must use this sequence to delete the incorrect number and then re-enter the entire number from the
beginning.
