L
K
J
A
4
a.
Slip the ring terminal lead (J) followed by the
lockwasher (K) over the threaded end of the
probe (A). Tighten the wing nut (L) onto the
probe to approximately 1/2 ft•lb (.65 N•m).
A
Q
J3
b.
Connect the probe (A) to the wiring circuit by sliding the
female quick-connect terminal of the probe wire onto the
male spade terminal J3 probe (terminal may be marked
J7 on older units).
F
F
G
b.
Using a flathead screwdriver, loosen the probe
mounting screws (F) 1/8" (3mm) about 1-1/2
turns and slip the control housing (G) over these
two screws at a 20˚ angle.
20
°
G
c.
Rotate the control housing (G) 20˚ counter-clockwise
so that the slots in the control base are firmly under
the screw heads. Tighten the mounting screws (F) to
approximately 2 ft•lb (2.6 N•m).
d.
Identify a desirable location to mount the control assembly (G) and comply with the following steps:
1. Using a level, draw a horizontal line at the
location and mark two positions 1-1/4" (31.75
mm) apart on the horizontal line.
2. Drill a 0.113 dia. hole 1/2" (13 mm) deep in
each position on the horizontal line.
3. Insert the two (2) sheet metal screws (provided)
into the two holes. Using a flathead screwdriver,
tighten the screws so that the base of the screw
head is 1/8" from the mounting surface.
* Repeat Steps 2b. and 2c. above.
1
1
/
4
"
(31.75mm)
Remote Mounting
Direct Mounting
Direct Mounted Probe
STEP 3 - Probe Wiring
STEP 2 - Installing Control Box (continued)
