ITT Flygt 5150.350, Инструкция по установке, эксплуатации и обслуживанию

Страница: 38 / 48

Replace the agitator
1
2
3
4
5
6
7
8
9
1. Impeller screw
2. Tension pin
3. Barrel nut
4. Propeller shaft
5. Agitator propeller
6. Washer
7. Retaining ring
8. Propeller screw
9. Wear protection/plug
Remove the agitator unit
Remove the necessary pump parts to make the agitator area accessible.
1. Lock the impeller:
If applicable use a rod (wooden or plastic) or a chain to lock the impeller in place.
2. Remove the wear protection/plug.
3. Remove the propeller screw.
4. Remove the retaining ring and the washers.
5. Remove the propeller from the propeller shaft:
a) Put the propeller screw in its hole.
b) Place the washer on the top of the propeller screw, and insert the retaining ring into the groove in
the propeller.
c) Undo the propeller screw.
This causes the head of the propeller screw to press the propeller outward.
Maintenance (Continued)
36 Flygt 5150.350, 5150.360 Installation, Operation, and Maintenance Manual