Make sure external power is not connected. Depending on power settings, some systems will not suspend
automatically when they are connected to external power.
Make sure the standby time is set properly in the Power Management program.
The system date and time are incorrect
Reset the correct date and time by choosing the Date/Time icon from Control Panel and making the
appropriate changes.
I receive an “out of memory” error message
Too many applications may be running at the same time. Close applications you don’t need.
Run
MS-DOS
applications in full screen rather than a window. Press
ALT
+
ENTER
to toggle between full
screen and window mode.
If you’re using
desktop
wallpaper, set wallpaper to None. To do this, choose Display from Control Panel
and make the appropriate change.
Make sure you have enough space on your
hard disk
. Contact your supervisor or your organization’s help
desk for assistance.
Set up a permanent swap file. Contact your supervisor or your organization’s help desk for assistance.
Holding down the Power button to reset the computer doesn’t always work
Try resetting the computer again. If this doesn’t work, remove all power, including the battery pack, and
allow the unit to remain idle for ten minutes. After ten minutes, connect external power and retry.
The LED's, backlight, and/or keyboard backlight don't illuminate.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable
Stealth mode
.
The computer doesn't make any sounds, even during boot-up.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable
Stealth mode
.
The fan stopped running.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable
Stealth mode
.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Page 71 of 74
GoBook II Help
9/30/2003
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hhDDD5.htm
