72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Display
The display performance is slow
The temperature may be too cold. Move the computer to a warmer operating environment.
I can’t read the display
Adjust the brightness level using
FN
+
F6
and
FN
+
F7
.
The automatic power-saving mode may have shut off (suspended) the computer. Press any key to resume.
If the display brightness is unreadable after a resume or reboot but is easily adjusted with
FN
+
F6
and
FN
+
F7
you may have set Stealth mode in the Setup Utility. If you disable
Stealth mode
the display and
backlight will operate normally.
The underlined, inverse, and hypertext characters are difficult to read on the screen
Change the color scheme. From the Start Menu select Settings, Control Panel, choose Display, and then tap
the Appearance tab to make changes to the color scheme.
I can’t see the cursor while using the DOS editor
Press
FN
+
INSERT
to change from insert mode to overwrite mode to enable a block cursor. When it
defaults to insert mode, the DOS editor uses an underline cursor which is less visible than the block cursor
for overwrite mode.
The display appears to have random pixels darkened after scrolling
Contact your supervisor or your organization’s help desk for information about correcting this problem.
I changed my display resolution, but I see no difference on the screen
Try restarting your computer for the changes to take effect.
GoBook II™ Help
Page 66 of 74
GoBook II Help
9/30/2003
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hhDDD5.htm
