Changing the Battery
Change the main battery pack as follows:
1. Turn off the computer.
2. Disconnect
external power
.
3. Close the display and turn the computer over.
4. Rotate the latches on the battery door to the open position and
remove the door. Remove the battery.
5. Make sure the replacement battery is properly orientated. Insert
the battery into the battery compartment. Check that the latches
lock back into position.
6. Charge the new battery by plugging the computer into AC power.
Heat Considerations
The computer’s processor has been specially designed to consume little power and generates very little heat. However,
working in a hot environment, or working for long periods may raise the temperature. Your computer takes the
following steps to lower temperature:
1. The cooling fan turns on. You may hear the fan and feel air coming from a vent near the right rear of the
computer when this happens.
2. If the temperature continues to rise, Processor activity is reduced. You may notice a slight loss of performance
when this happens.
3. If the computer overheats, the processor will stop functioning and the computer will shutdown.
72_0103_003
10 December 2002
© 2002 Itronix Corporation. All rights reserved.
Customizing Your CMOS Settings
This chapter explains how to use the Setup
Utility
to modify the CMOS settings. The Setup Utility displays and allows
modification of the GoBook II components and the configuration of devices that are connected to it. This information is
used to test and initialize components at start-up time and to make sure everything runs properly when the system is
operating.
The GoBook II is configured with a set of default values. You may be able to increase system performance by changing
Page 34 of 74
GoBook II Help
9/30/2003
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hhDDD5.htm
