Tip:
To remove the cable, pull the silver tab on the power cable back. Twist the
connector so the silver tab lines up with the labeling on the junction box, and release
the tab to unlock it. Then gently pull back on the connector to remove it.
2. Plug the other end into the power in receptacle on the radio.
Connecting the Antenna
The omni-directional RF antenna has either a fixed-base that is permanently attached to the
vehicle or a magnetic base that can be attached to and removed from the vehicle as necessary.
When deciding where to mount the antenna, consider the following:
■
Choose a flat area on the vehicle's roof, where the metal of the roof is 0.02-0.04 inches thick.
■
Install the antenna a minimum of 12 inches (recommended 30 inches) from any other
antennas or metal structures on the vehicle’s roof that could disrupt communication with
endpoints.
■
To meet RF exposure safety requirements, the antenna must be installed 7.9 inches (20 cm)
from where any bystanders might be.
Connecting the Antenna to the Mobile Collector Radio
Connect the omni-directional RF antenna cable to the MAIN ANTENNA connector on the
MC3Lite or MC3 radio as shown in the following illustrations. Be sure to properly tighten the
connector. A loose connection can lead to poor radio and read performance.
Note:
Antenna cables from previous Mobile Collection systems might not be compatible with
the connector on your new Mobile Collector radio. Install the omni-directional antenna that is
provided with your new Mobile Collection system. If needed, a type N to TNC adapter (part
number CON-0419-001) can be ordered from Itron. Contact Itron Customer Service at
1-877-487-6602.
07 May 2020
815-0207-00 REV 000
Itron, Inc. Page 35 of 44
Vehicle Preparation and Hardware Installation Guide
3 Installing Mobile Collection Components