Itm TM356-15500, Руководство оператора

Страница: 26 / 32

English
27
Code 1625186897- Edition 7/2019
Every 2000 hours
(OR 1/2 Year)
B
   
Change the oil filter (see control board LED)
 
Change the suction filter (see control board LED)
   
Clean the finned surface of the air-oil cooler
   
Change the oil separating filter
(see control board LED)
   
Top up Grease on Motor (see control board LED)
Every 4000 hours
(OR 1 Years)
C
   
All maintenance content of plan B
   
Test the emergency stop function
   
Change the belt
   
Test the safety valve (or one year, whichever is first)
Every 8000 hours
(OR 2 Years)
D
   
All maintanence contents of plan C
   
Change the suction valve service
   
Change the MPV service
   
Change the check valve
   
Clean the oil carbon (using the company's proprietary
carbon cleaning agents)
Every 12000 hours
(OR 3 Years)
E
   
All maintanence contents of plan C
   
Check the bearing of the motor.
Every 20000 hours
(OR 4 Years)
F
   
All maintanence contents of plan C
   
Test and change the motor bearings
   
Check the Air End bearings.
BEFORE CARRYING OUT ANY MAINTENANCE JOBS IT IS OBLIGATORY TO STOP THE
MACHINE AND DISCONNECT IT FROM THE POWER MAINS.
15.4 CHECK OIL LEVEL AND TOP UP
- Switch off the machine using the button Ref. 2 Fig. 16: the machine will stop after running unloaded
for few seconds.
- Wait a few minutes for the foam in the air/oil separtor tank to abate (check sight glass).
- Check the oil level on the indicator Ref. 4 Fig. 16
- If the oil level is under the minimum, top up.
USE OIL OF THE SAME TYPE AS THAT ALREADY IN THE MACHINE; DO NOT MIX
DIFFERENT TYPES OF OIL.
BEFORE CARRYING OUT ANY OPERATION ON THE MACHINE, ENSURE THAT THE
ELECTRIC POWER SUPPLY HAS BEEN DISCONNECTED.
Proceed as follows to top up (see 18.0 for oil part number)
- Open the front panel with the special key
- Slowly open the oil plug Ref. 5 Fig. 16
- Top up to maximum level Ref. 4 Fig. 16, with oil of the same type in the compressor.
- Turn off the cap of the oil tank Ref. 5 Fig. 16.
- Close the panel.
Note: If the oil has turned Creamy in Color contaminated with Condensate, Immediately contact
dealer or Manufacturer, Do not operate the machine
15.5 CLEANING THE FILTERING PANEL
- Press the “STOP” button Ref. 2 Fig. 16
- Press the “EMERGENCY STOP” Ref. 5 Fig.5.
- Turn power off from the mains.
- Clean the filtering panel with a jet of air or wash it with water, do not use solvents.
- Once the operation has been completed, re-assemble the filter panel. Turn the power on.