Isuzu NOVOULTRA E6 2019, Руководство пользователя

Страница: 79 / 102

75
Engine-side Fuel Filter (All Models)
1. Connect one end of a plastic hose to the
drain plug at the bottom of the engine-
side fuel filter and place the other end of
the hose inside a container to receive
the drained fluid.
2. Loosen the drain plug and move the
priming pump up and down by hand
between 10 and 20 times.
3. Fully tighten the drain plug and move the
priming pump several times.
4. Test run the engine and check that there
are no fuel leaks from the drain plugs of
the chassis-side fuel filter and engine-
side fuel filter. Also check that the water
separator (fuel filter) warning light stays
off.
•
Clean off any fuel that has adhered to the vehicle body.
•
Starting the engine immediately after draining the water from the
fuel filter requires a little more time than usual. If the engine doesn't
start in 10 seconds, wait for a while and try again.
•
Fuel will be mixed in the drained water. Dispose of it in a method
conforming to the regulatory requirements in your country.
•
If the water separator (fuel filter) requires frequent draining, have
the fuel tank drained at your Isuzu service. It would be better not to
use the water separator (fuel filter), since it may possibly exert a
bad effect on the fuel system.