iSocket
®
GSM 706/707
www.isocket.eu
© Copyright Intellectronics 2012
All rights reserved. Version 1.1.2-EN
- 9 -
English
4. Managing the iSocket Device
You can manage the device with SMS-commands, by phone call or manually. SMS
management offers best performance.
4.1 Managing by SMS
Commands are sent in form of SMS messages to the SIM-card number of the iSocket.
Messages have the following syntax:
COMMAND
(for example,
STATUS
).
If a password was configured (see Chapter 5), then you must use following syntax:
passwordCOMMAND
(for example,
12345STATUS
),
where
12345
is a password set by the command
PASSWORD=12345
(more details in Chapter 5).
There are three types of commands:
Configuration commands
(marked "
30min
" in the tables)
Allow parameters and functions to configure the iSocket device. The configuration can only be
performed within 30 minutes after device has been powered on or after the last configuration
command has been received. If you try to configure device after 30 minutes, then you will get the
message "
command – Time for configuration is expired (30min)
" (only if ERROR=ON - see Chapter
6). To remind the user of this limit we have marked configuration commands as "30min" in the column
"type" in the tables. Settings are stored in non-volatile memory and are not lost when power is off.
Information configuration commands
(marked "
Inf"
in the tables)
These commands have a question mark at the end (
COMMAND?
). These are information commands.
In response you will receive the current value of the parameter, which has the same name as the
command. These commands do not activate the configuration, but only inform you of the value. These
commands are available at any time. You can set up the facility to reset the configuration interval (see
section 5.3).
Control and management commands
(marked "
Ctrl
" in the tables)
Used to control the iSocket device and can be used at any time.
Each command has a default value. This is the value that was installed at the factory
(for details see Chapter 15). Commands are not case sensitive. You will get a response
after sending the command. This can be disabled if desired (see Chapter 6).
Should a
configuration
command have different values these will all be seen in response
to the
information
command associated with this configuration command. The values
will be comma-separated and the current active value will be indicated in parentheses.
For example, you send the information command "
COMMAND?
". In response you will get
the reply "
COMMAND=OFF,(ON)
". This means that the current active value is "
ON
", and
"
OFF
" is another value acceptable for this command. This syntax is made for your
convenience - you do not need to refer to the manual each time when to remember all
possible values. They will be given in the response. The first value in the response is the
factory default value (see Chapter 15).
If you make a mistake in the command and send an incorrect command, you will receive
a message "
command - Error!
" (Only if ERROR=ON - see Chapter 6). If a command
longer than 30 characters was sent, it will be deleted without any response notifications.
NOTE!
Configuration commands are only accepted during the first 30 minutes after
powering on. This is for security reasons. If you want to reconfigure the device, you
must disconnect it from the mains outlet and turn it on again. You can also set up the
facility to reset the configuration interval (see section 5.3).
Содержание GSM 706
Страница 1: ......
