CNC control panel iOP-19-TFT
Page - 10
Screen control elements
The screen control elements are located in the service hatch
3
Control element connection
All CNC control panel connecting cables are optimised for use with isel
iSR/iPC series control computers. These connecting cables should not be
extended. Doing so may impair the performance of the CNC control panel.
Ensure the protective earth conductor is adequate with a diameter of at
least 2.5mm
2
(screened cable) or 4mm
2
(un-screened cable) and
connected between the iOP-19 terminal
and the safety bus bar of
your machine!
3.1 Connecting the control PC control elements
DVI connecting cable
This cable is fitted with a DVI plug for connection to the graphic card of
your computer.
No.
Element
Description
1
Menu (top)
Use the menu to navigate to the top
2
Menu (bottom)
Use the menu to navigate to the bottom
3
ON / OFF
Switches the monitor "on" and "off"
4
Menu (enter)
Opens the menu / confirms settings
5
Menu (back)
Steps the menu back one level
6
LED
Indicates operating condition: red
off, green
on
1
2
3
4
5
6
12
