iQPC912VSK
Operator’s Manual
888-274-7744
www.iqpowertools.com
Starting A Warm Engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position.
When the engine starts, quickly apply full throttle to
automatically disengage fast idle.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
STOPPING
The engine is stopped by pressing the ignition switch to
the off position.
Spin Filter Instructions
Spin the filter handle once after each cut.
When making longer cuts, stop every 12 inches and
allow the blade to stop, spin the filter handle three times
around then continue cutting.
Keeping the filter clean is essential for proper operation
and effective dust capture.
DUMPING DUST AND DEBRIS
After cutting approximately 5 feet or cycling the filter
five times the lower dust collection chamber will be full
and must be dumped.
DUST COLLECTION SYSTEM INSTRUCTIONS
(A) Using a suitable
container to hold dust
( 5 gallon bucket or similar)
- With engine idling hold
the iQPC912 at a 45° angle
over the container.
(B) Release the dump
door latch
(C) Pull the dump door
lever to open dump door.
- Wait a few seconds to
allow dust and debris
to slide out of the lower
dust chamber.
- Spin the filter handle a
few times to ensure
the filter is clean allowing
dust and debris to fall into the lower dust chamber.
Pull the dump door lever
to open (D) the dump door
again allowing any residual
dust and debris to slide out.
- Visually inspect no more
dust or debris is coming
out, release the door pull
lever allowing the dump
door to return to its closed position.
(E) Rotate the dump door
latch to the right or locking
position.
Continue cutting
WARNING!
KEEPING THE FILTER CLEAN
AND DUST CHAMBER EMPTIED
IS ESSENTIAL FOR PROPER OPERATION AND EFFECTIVE
DUST CAPTURE. FAILURE TO DO SO WILL RESULT IN POOR
DUST COLLECTION PERFORMANCE AND EXPOSURE TO
HARMFUL DUST.
Содержание iQPC912VSK
Страница 2: ...M iQPC912VSK 0M 1218 ...
Страница 29: ...888 274 7744 WWW IQPOWERTOOLS COM ...