IQ Power Tools iQPC912VSK, Руководство оператора

Страница: 5 / 29

iQPC912VSK
Operator’s Manual
888-274-7744
www.iqpowertools.com
Safety Rules
1. KEEP GUARDS IN PLACE
and in working order.
2. REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
3. KEEP WORK AREA CLEAN.
Cluttered areas and
benches invite accidents.
4. KEEP CHILDREN AWAY. All visitors should be kept
at a safe distance from work area.
5. DON’T FORCE TOOL
. It will do the job better and
safer at the rate for which it was designed.
6. USE RIGHT TOOL. Don’t force tool or attachment
to do a job for which it was not designed.
7. WEAR PROPER APPAREL.
Do not wear loose
clothing, gloves, neck ties, rings, bracelets, or other
jewelry which may get caught in moving parts.
Nonslip footwear is recommended. Wear protective
hair covering to contain long hair.
8. ALWAYS USE SAFETY GLASSES.
Also use face
or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact resistant lenses, they
are NOT safety glasses.
SAFETY RULES
9. DON’T OVERREACH. Keep proper footing and
balance at all times.
10. MAINTAIN TOOLS WITH CARE. Keep tools
sharp and clean for best and safest performance.
Follow instructions for lubricating and changing
accessories.
11. REDUCE THE RISK OF UNINTENTIONAL STARTING.
Make sure switch is in off position.
12. USE RECOMMENDED ACCESSORIES. Consult the
owner’s manual for recommended accessories. The
use of improper accessories may cause risk of injury
to persons.
13. NEVER STAND ON TOOL. Serious injury could
occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
14. CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function
- check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation.
A guard or other part that is damaged should be
properly repaired or replaced.
15. DIRECTION OF FEED. Feed work into a blade or
cutter against the direction of rotation of the blade
or cutter only.
16. NEVER LEAVE TOOL RUNNING UNATTENDED
TURN POWER OFF. Don’t leave tool until it comes to
a complete stop.
2.1