IQ Power Tools iQPC912VSK, Руководство оператора

Страница: 23 / 29

iQPC912VSK
Operator’s Manual
888-274-7744
www.iqpowertools.com
Squeeze the excess oil out of the filter inside the plastic
bag and pour off the excess before fitting the filter to
the machine. CAUTION! Never use common engine oil.
The paper filter (E) is accessible under cover (D) This
filter must be replaced/cleaned when the engine’s
power drops or each month. The filter is cleaned by
shaking. Note that the filter must not be washed.
NOTE! High pressure compressed air can damage the
filter. An air filter that has been in use for a long time
cannot be cleaned completely. The filter must therefore
be replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
STARTER
Changing a broken or worn starter cord
(A) Loosen the screws that hold the starter against the
crankcase and remove the starter.
(B) Pull the cord out about 12 inches or 30 cm and lift
it into the cut-out in the periphery of the starter pulley.
When the cord is intact: Release the spring tension by
letting the pulley rotate slowly backwards.
MAINTENANCE & TROUBLE SHOOTING
(C) Remove any remnants of the old starter cord and
check that the return spring works. Insert the new
starter cord through the hole in the starter housing and
in the cord pulley.
(D) Secure the starter cord around the cord pulley as
illustrated. Tighten the fastening well and ensure that
the free end is as short as possible. Secure the end of
the starter cord in the starter handle.
(E) Guide the cord through the cut-out in the periphery
of the pulley and wind the cord 3 times clockwise around
the center of the starter pulley.
WARNING!
WARNING! WHEN THE RECOIL
SPRING IS WOUND UP IN THE
STARTER HOUSING IT IS UNDER TENSION AND CAN, IF
HANDLED CARELESSLY, POP OUT AND CAUSE PERSONAL
INJURY. ALWAYS BE CAREFUL WHEN CHANGING THE
RECOIL SPRING OR THE STARTER CORD. ALWAYS WEAR
PROTECTIVE GOGGLES.