IQ Power Tools iQPC912VSK, Руководство оператора

Страница: 22 / 29

iQPC912VSK
Operator’s Manual
888-274-7744
www.iqpowertools.com
- If the spark plug is dirty, clean it and at the
same time check that the electrode gap is
.030” or 0.75mm (B)
- CAUTION! Always use the recommended spark
plug type! Use of the wrong spark plug can
damage the piston/cylinder.
COOLING SYSTEM
To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1. Air intake on the starter.
2. Air guide plate.
3. Fins on the flywheel.
4. Cooling fins on the cylinder.
5. Cylinder cover
6. Muffler cooling shield
Clean the cooling system with a brush once a week,
more often in demanding conditions. A dirty or blocked
cooling system results in the machine overheating which
causes damage to the piston and cylinder.
MUFFLER
The muffler is designed to reduce the noise level and to
direct the exhaust gases away from the operator. The
exhaust gases are hot and can contain sparks, which
may cause fire if directed against dry and combustible
material.
Never use a machine with a defective muffler.
WARNING!
WARNING! DO NOT START THE
MACHINE WITHOUT THE BEAM
OR CUTTING HEAD FITTED. OTHERWISE THE CLUTCH
COULD COME LOOSE AND CAUSE PERSONAL INJURIES.
MAINTENANCE & TROUBLE SHOOTING
FUEL FILTER
• The fuel filter sits inside the fuel tank.
• The fuel tank must be protected from contamination
when filling. This reduces the risk of operating
disturbances caused by blockage of the fuel filter
located inside the tank.
- The fuel filter cannot be cleaned but must be
replaced with a new filter when it is clogged.
The filter should be changed at least once per year.
AIR FILTER
Air filters must be regularly cleaned to remove dust and
dirt in order to avoid:
- Carburetor malfunctions
- Starting problems
- Loss of engine power
- Unnecessary wear to engine parts.
- Excessive fuel consumption.
The air filter system consists of an oiled foam plastic
filter (C) and a paper filter (E):
The foam pre-filter (C) is easily accessible by removing
the filter cover screws (A) and removing the filter cover
(B) This filter should be checked weekly and replaced if
necessary. In order to obtain a good filtering effect, the
filter must be replaced regularly or cleaned and oiled.
A special iQ Power Tools oil has been produced for this
purpose. Remove the foam pre-filter (C) Wash the filter
well in tepid soapy water. After cleaning, rinse the filter
well in clean water. Squeeze out and allow the filter to
dry. NOTE! High pressure compressed air can damage
the foam. Put the filter in a plastic bag and pour the
filter oil over it. Knead the plastic bag to distribute the oil.