IPG RSA 2024-SB, Руководство по эксплуатации и список запасных частей

Страница: 41 / 117

UM122TW / UM622TW UDM10012
41
T
ROUBLESHOOTING
The RSA 2024-SB is fabricated with high quality components that provide trouble-free operation
for a long period of time. However, should a problem occur, we recommend that you consult
the following table. If the problem you encounter is not discussed in this table, call Interpack
Technical Support (see
Page 4 of this document).
Trouble Possible Causes Solutions
Green start button
depressed but belts do
not turn.
E-Stop not Re-Set
Machine Not Plugged In
“Clear” mode still active
Rotate E-Stop 1/4 Turn
Clockwise.
Plug Machine Into 110 V, 60 Hz,
15 Amp Electrical Service.
Press down on the “Clear” button
to take machine off “Clear” mode
Air is supplied. Main
power is turned “on”
and nothing happens.
Overload protection by circuit
breaker
E-Stop not Re-Set
Check that all circuits are “on”.
Rotate E-Stop 1/4 Turn
Clockwise.
Drive belts do not
process cases.
Belt tension Too Low
Collapsed Leading End Panel On
Case.
Case Size Is Out Of Specification.
Re-Tension Drive Belts, (
See
Page 52 )
-Install Lighter Gauge Tape Head
Main Spring
-Reduce Unwind Tension On
Tape Roll
a. Mandrel Tension
b. Clutch Roller Tension
Compare Case Sizes With
Machine Specifications,(
See
Page 20 )
Top tape head box has
no action, either at
down, up, or half-way
position. Drive bases
stay closed onto a box.
When machine has been activated
without a box.
Reset machine operation using
the “Clear” button then set the
operation selection switch to
AUTO to resume operation.