2016-0685
2017-10-02
Setup the spa with at least 2 persons.
1.
Move the entire package to the selected site. Do not drag the spa
tub across the ground as this can cause damage and leakage.
Open the carton carefully as this carton can be used to store the spa
during long term storage or when not in use.
2.
Lay out all the parts on the ground and make sure all the parts are
accounted for
.
For missing or damaged parts contact the
appropriate Intex Service Center listed in the separate “Authorized
service Centers” sheet.
3. Safety Sign Card Posting
4.
The Safety Sign card included with the manual shall be posted in an
area visible to the users of the spa to alert them of the safety rules and
warnings. For replacement of the safety sign card, visit our website at
www.intexcorp.com for additional print copies. Laminate the printed
safety sign copy for protection from the elements.
Spa Control Unit Assembly
1.
Connect the control panel
(3)
cable plug into the receptacle on top of
the spa control base and screw in the plug cover firmly by hand
(see
drawing 1). Note:
Spread the ground cloth with the bubbles facing
down over the cleared area where you intend to setup your spa.
2.
Screw the control panel bolts
(4)
with the provided bolt wrench
(6)
to secure the
control panel
(see drawing 2).
3.
Plug the spa control unit into a grounded electrical outlet.
For indoor inflation:
Inflate the Spa Tub Wall
1.
Take out the ground cloth
(19)
and spread it over the cleared area.
Then spread out the spa liner over the ground cloth and point the
drain valve towards a suitable draining area.
NOTE:
Spread the ground cloth with the bubbles facing down over
the cleared area where you intend to setup your spa.
2.
Unscrew the control base inflatio
n cap
(9)
to reveal the air blower
inflation outlet, insert one end of the inflation hose
(7)
into the outlet
and turn to the right to lock it
(see drawing 3).
3.
Unscrew the air valve cap to reveal the stem in the up position for
inflation. Insert the other end of the inflation hose
(7)
into the valve
and turn to the right to lock it in position
(see drawing 4).
4.
Press the button to turn on the control unit panel buttons first. Press
the button to inflate the spa tub wall until it is firm to the touch but not
hard
(see drawing 5)
.
IMPORTANT:
Do not over inflate or use high pressure air compressor to inflate.
5.
Press the button again to turn it off.
6.
Disconnect the inflation hose
(7)
from the air valve and attach the
