2016-0685
2017-10-02
SPA. Salt is not lost due to evaporation.
• Adding Salt
1.
Switch the JET pump on to start the water circulation.
2.
Keep the sanitation system turned off.
3.
Evenly spread 2 kg / 4.4 lbs of salt around the inside perimeter of the SPA.
4.
Brush the SPA bottom to speed up the dissolving process. Do not allow salt to
pile up on the bottom of the SPA. Run the JET pump for one hour to thoroughly
dissolve the salt.
5.
When all the salt is dissolved, press the sanitizer button to activate the sanitation
system (see “Sanitation System Operating Instructions” section), code “003H” is
flashing and set the sanitation system to desired operating hours.
NOTE:
DO
NOT press any other buttons on the control panel, ensure the heater is off and
attach the spa cover during the sanitizing process.
• Removing Salt if Salt Level is too high
If too much salt has been added, the unit will beep and display “E92” (see “LED Code
Chart”). If this happens, turn off the sanitation system by pressing the ON/OFF button
,
and unplug the spa. You will need to lower the salt concentration. The only way to do
so is to partially drain the SPA and refill it with fresh water. Drain and refill approximately
25% of the SPA water until the “E92” alarm code disappears.
• Adding Salt if Salt Level is too low
If not enough salt has been added, the unit will beep and display “E91” (see “LED Code Chart”).
If this happens, turn off the sanitation system by pressing the ON/OFF button
, unplug the
spa and wait 10 seconds. Plug and turn on the spa, add 0.5 kg / 1.1 lbs increment of salt until
the “E91” alarm code disappears (see “Adding Salt” section).
On/Off Button:
Once the unit is plugged in, use this button to active
the control unit panel buttons. The light next to the button is green
when activated. Press this button to turn off all currently activated
functions.
NOTE:
The On/Off button may appear as a black button in
the center of the control panel.
Heat Button:
Use this button to activate the heating system. The
pump will heat the spa water until the water temperature reaches
the set temperature. When the spa water temperature drops 3.6°C
(2°F) below the set temperature the heating system will restart.
When the flame icon on the display is red, the heating system is
activated. When the flame icon turns green, the water is at the set
temperature. The heating system is at rest and the filtration system
will continue working nonstop.
NOTE:
To stop the filtration system while the heater is at rest mode,
press the flame button first and then the filter button. Pressing the
flame button only while the heater is at rest mode will turn off the
