IntesisBox
®
PA-AC-ENO-1i / 1iC
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
30 / 43
8.5 Control & monitor the IntesisBox
®
from a software application
a)
Control the IntesisBox
®
from a software application:
Follow the steps in section 4.3.2 (learning gateways) and instead of steps 3 and 4
(selecting profile F and pressing the Teach-in button of the gateway), three Teach-in
telegrams corresponding to EEPs 07-20-10, 07-20-11 and 07-10-03 must be sent by the
software application.
See the description of the Teach-in telegrams structure in section 12.
b)
Monitor the IntesisBox
®
from a software application:
Teach profile F to the software application. See section 4.2.2.
8.6 Configure parameters
The IntesisBox
®
parameters can be configured using the Intesis Configuration Software
(section 5.3).
8.7 Check if the devices have been correctly learnt
a)
Using the Intesis Configuration Software, load the reception profiles and check that
the device has been learnt in the correct profile.
b)
Enable monitor mode (section 4.2.1) and check if the device has been learnt or. It
will not be possible to know if it is learnt in the desired profile.
8.8 Protect the IntesisBox
®
from undesired remote access
It can be achieved either by remote configuration or using the switch S4-3. Even both
protection methods can be performed:
a)
If using remote configuration: See Intesis Configuration Software documentation.
b)
If using manual configuration: Section 4.5.
8.9 Improve radio coverage of IntesisBox
®
It is important to set the antenna cable as much straight as possible, trying to avoid angles
in this cable and with no loops.
Changing the location of the antenna cable might improve the radio coverage of the
IntesisBox
®
, which will depend on the position of the IntesisBox
®
.
