IntesisBox
®
PA-AC-ENO-1i / 1iC
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
14 / 43
S4
– EnOcean switches: normal mode, learning mode, erasing mode and remote
management enabling/disabling:
Binary
value
b
3
…b
0
Decimal
value
Switches
1 2 3 4
Description
00xx
0
x x
Normal mode (default value). See section 4.2.
01xx
1
x x
N/A (behaves as normal mode)
10xx
2
x x
Learning mode. See section 4.3.
11xx
3
x x
Erasing mode. See section 4.4.
xx0x
0
x x
x
Remote management enabled (default value). See section 4.5.
xx1x
1
x x
x
Remote management disabled.
xxx0
0
x x x
N/A
xxx1
1
x x x
N/A
Table 4.2
S4 switch configuration
The different actions that can be performed in each mode are described in this section.
4.2 Normal mode
While the normal mode is selected it is possible to set the device to monitor mode and
perform the teach-in procedure. These operations will not interfere in the normal behaviour
of the device.
4.2.1 Monitor mode
Due to the transmitting method (radio) of EnOcean telegrams, is possible that the
IntesisBox
®
is outside the coverage range of one device. For that reason, the interface, as a
receiver, has the ability to show when it receives EnOcean telegrams from a linked device
when in monitoring mode.
To
activate
the monitoring mode (check Figure 4.1):
1.
Make sure that IntesisBox
®
is working in normal mode (switches S4-1 and S4-2 set
to OFF)
2.
Press S3 for 5 seconds. The L1 will briefly flash (100ms). From then on, L1 will flash
for 100ms each time that a valid telegram from a learnt device is received.
To
disable
the monitoring mode:
1.
In order to disable the monitor mode it is necessary to set EnOcean switches (S4) to
learning or erase mode. Once S4 is set to normal mode again the monitor mode will
be disabled
Mode
L1
Normal mode (monitor mode enabled)
Off
Normal mode (monitor mode disabled) Flashing (100ms) per telegram received
Table 4.3
L1 and monitor mode
