IntesisBox
®
PA-AC-ENO-1i / 1iC
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
18 / 43
Important!
In Profiles E and F up to 5 devices can be linked. It needs to be taken into account that if
the devices are linked by the MultiTeach-in procedure (more information in section 6.5) only
one is going to be fully linked as it would take 3 of the 5 spaces available.
4.4 Erasing mode
In order to delete the devices that have been learnt the erase mode needs to be selected. It
is possible to delete the devices one by one, to delete all the devices linked in one Rx profile
(Table 4.5) and perform a “return to factory settings”.
4.4.1 Deleting one by one
To delete the linked devices one by one it will be necessary to have the linked device
working properly. To do so follow next lines (the references to device components are
specified in Figure 4.1):
1.
Set the switches S4-1 and S4-2 to ON. L1 will turn into flashing (100 ms on and 100
ms off).
2.
Set the profile selector (S2) to the desired Rx profile (Table 4.5) where the device to
be deleted is saved.
3.
Push the Teach-in button of the device that want to be deleted, or if they don’t have
the Teach-in button (as the EnOcean switches) action them. Once the telegram is
received L1 will be on for 1 second to show that the device has been deleted
correctly from this profile.
4.
Once finished, set the switches S4-1 and S4-2 to OFF for a normal operation of the
device.
4.4.2 Deleting all the devices linked to one profile
A device can break down or be lost, and therefore the above mentioned delete procedure
would not be possible to be executed. For that reason all the devices in one profile can be
deleted. To do so follow the instructions (the references to device components are specified
in Figure 4.1):
1.
Set the switches S4-1 and S4-2 to ON. L1 will turn into flashing (100 ms on and
100ms off).
2.
Set the profile selector (S2) to the desired Rx profile (Table 4.5).
3.
Press the button S3 for 5 seconds. Once that is done the L1 will be on for 1 second
to show that all devices in this profile have been deleted.
4.
Once finished, set the switches S4-1 and S4-2 to OFF for a normal operation of the
device.
