Interlogix UltraView IP PTZ 36X, Руководство пользователя

Страница: 27 / 82

Chapter 4: Camera setup
UltraView IP PTZ 36X Camera User Manual 23
Camera configuration
This section describes how to configure the camera settings from the Channel
Parameters screen. There are eight subfolders, which are described below:
• Display settings : Defines the how the name and date/time are displayed on
screen. By default the name appears in the lower right corner of the screen
and the date/time on the top. See “Display information” on page 24 for more
information.
• Video settings : Defines how the camera records an event. The stream
mode, stream type, resolution, image quality, bit rate, frame rate, and video
compression can all be modified. See “Video recording parameters” on page
25 for more information.
• Schedule recording : Defines the schedule when the camera records.
“Defining a recording schedule” on page 27.
• Motion detection : Defines the on-screen area to trigger a response, the
detection schedule and method of response. See “Motion Detection” on page
36.
• Video tampering : Defines the on-screen area to trigger a response, the
detection schedule and method of response. See “Camera tamper alarm” on
page 29.
• Text overlay : Defines up to four lines of extra text on screen. They can be
positioned anywhere. See “Adding extra text on-screen” on page 31.
• Camera settings : Defines the camera image quality and behavior
parameters such as shutter speed, iris mode, day/night mode, image flip, and
white balance. See “Camera image settings” on page 32.
• Reset image : Resets the camera settings to the previously configured and
saved values. See “Reset ” on page 35.
• Restore image : Restores the camera settings to factory default. See
“Restore ” on page 35.
All changes made apply only to the camera being configured. Parameters cannot
be copied to another camera.
Note: When schedule parameters are modified, the camera will prompt you to
reboot after the changes are saved.