Intergraph InterServe 05 Setup, Руководство по установке

Страница: 45 / 75

32
Installed Memory Speed
InterServe 305 and 605 servers use 60 ns memory SIMMs, so this parameter is set to 60 ns by
default. The other choice is 70 ns, which should not be used. If you set this parameter to
70 ns, the system will not boot.
Peripheral
Peripheral contains parameters that affect option boards, serial ports, and parallel port
functionality.
Programming Mode
This parameter detects all installed option boards and configures the on-board components
accordingly. When set to Auto (the default), the system BIOS automatically detects the
installed option boards during boot up. When set to Manual, the next four parameters, plus
Parallel Port IRQ, activate.
OnBoard FDC
When set to Enabled (default), this parameter enables the system floppy disk drive I/O
controller on the system board. If you install floppy controller cards, then this parameter must
be set to Disabled.
Serial Port1
This parameter enables the use of serial port 1 on the system board by selecting a memory
address for the port. The values are Auto (default), Disabled, 3F8h, 2F8h, 3E8h, and 2E8h.
When set to Auto, the I/O controller selects an available address. The 3xxh and 2xxh values
correlate to a serial port, address range and interrupt as defined by the following table.
Value Serial Port Addresses Range Interrupts
3F8h COM1 3F8-3FF IRQ4
2F8h COM2 2F8-2FF IRQ3
3E8h COM3 3E8-3EF IRQ4
2E8h COM4 2E8-2EF IRQ3