Intergraph InterServe 05 Setup, Руководство по установке

Страница: 23 / 75

9
If the system is connected to a network that uses the Transmission Control Protocol/Internet
Protocol (TCP/IP), obtain and record the following TCP/IP networking information from your
network administrator:
u
Internet Protocol (IP) address for your
system:
u
IP subnet mask for your system:
u
IP domain name for your network:
u
IP address for your network’s default
gateway:
u
IP addresses for your network’s
Domain Name System (DNS) servers,
if any:
The Windows NT delivery media contain software and drivers for both Reduced Instruction
Set Computing (RISC)- and Intel-based systems. When installing Windows NT distribution
files, make sure to install them from the \
I386
directory (the Intel software directory) on the
delivery media. For example, if you are installing a device driver from the Windows NT
CD-ROM, key in the following when asked for the path to the file, where drive is the drive
letter for the CD-ROM drive:
drive:\i386
Starting the System
WARNING If the AC voltage switch on the back of the desktop system base unit is not set to the
proper line voltage for your location, serious equipment damage may result when you
press the power switch.
WARNING Do not turn on system power until you are ready to configure Windows NT Server. If
you start the system, and then restart it before completely configuring Windows NT
Server, you will have to re-install Windows NT Server as described in the
System Setup
document delivered with the system.
To turn on system power, push the power switch until it clicks to the in position. After the
system boots, the Windows NT Setup screen is displayed on the monitor. The following
section describes going through Windows NT Setup.
The following figures show the front of the desktop and deskside systems.