Intergraph InterServe 05 Setup, Руководство по установке

Страница: 16 / 75

2
Placing System Components
CAUTION Do not move the base unit without first turning off the power, or damage to internal
components may result. Remember these guidelines when placing system components:
When placing system components, keep these guidelines in mind:
u
Move and place the monitor and the base unit carefully.
u
Place the base unit in a location where air can circulate freely around it. The front and
back panels should each have at least a 3-inch clearance. If a desktop base unit is
positioned horizontally, the sides should each have at least a 1-inch clearance.
u
Do not expose the system to high levels of dust, smoke, or moisture.
u
The location should maintain a temperature range of 10
°
C to 26
°
C (50
°
F to 80
°
F); the
optimum operating temperature is 21
°
C (70
°
F).
u
The location should maintain a humidity range from 20 percent to 80 percent non-
condensing; the optimum humidity level is 50 percent.
Setting Up the System
Follow the instructions in this section to set up the system and connect the cables. To prevent
damage to the system, follow the instructions carefully. Do not turn on the system until you
have properly connected all cables and have read the section, “Preparing for Windows NT
Setup” later in this chapter.
To set up the system:
1. If setting up a deskside system, or if setting up a desktop system in a vertical orientation,
place the footstands on the bottom of the base unit. Place the back footstand between the
ribs on the back and side of the base unit. The following figure shows placement of the
footstands on a desktop system.
WARNING To avoid personal injury or equipment damage, and to allow proper airflow, you must
use the footstands when setting up a desktop system base unit in a vertical orientation.
NOTE Ensure the CD-ROM drive is at the top when setting up a desktop system base unit in a
vertical orientation.