Intergraph InterServe 05 Setup, Руководство по установке

Страница: 21 / 75

7
CAUTION Connecting a non-compliant SCSI-1 device to your system may cause your system to stop
working, or lead to other unpredictable results.
3. Connect the device to the other end of the SCSI cable.
4. If necessary, install the device drivers and configure the device according to the vendor’s
instructions.
NOTE Information about configuring external SCSI devices is provided in Chapter 2, “Configuring the
System.”
Preparing for Windows NT Setup
The Windows NT Server operating system is partially installed on the system disk. After
setting up the system, you must start the system and complete Windows NT Setup to configure
the system for use. Parts of the installation procedure require information that you must
supply.
WARNING Do not turn on system power until you are ready to configure Windows NT Server. If
you start the system, and then restart it before completely configuring Windows NT
Server, you will have to re-install Windows NT Server as described in Chapter 5,
“Installing System Software.”
Before you begin, have the following available:
u
Microsoft’s Start Here document.
u
Documentation for any expansion boards purchased from Intergraph.
u
Several blank, formatted diskettes available to create backup diskettes containing system
software.
u
Intergraph backup diskettes delivered with your system.