Intergraph ExtremeZ GL1, Настройка системы

Страница: 44 / 110

30
Date/Time
Select this option to display or change the current system date and time values. The time
displays in 24-hour format.
Floppy A, Floppy B
Select these options to specify the type of floppy disk drive installed in the system.
Floppy A is preset to 1.44 MB 3.5-inch. Do not change this parameter unless you replace
floppy drive A with a different capacity disk drive. The Optimal and Fail-Safe settings are
1.44 MB 3.5-inch.
Floppy B is preset to Not Installed. Do not change this parameter unless you install an
optional floppy disk drive. The Optimal and Fail-Safe settings are Not Installed.
Advanced Menu
Select Advanced in the BIOS Setup main menu to display the Advanced Setup options.
Quick Boot
Set this option to Enabled to instruct the BIOS to boot quickly when the system is powered
on. The settings are:
Setting Description
Disabled The BIOS tests all system memory. The BIOS waits up to 40 seconds for a
READY signal from the IDE hard disk drive. The BIOS waits for 0.5 seconds
after sending a RESET signal to the IDE drive to allow the IDE drive time to
get ready again. The BIOS checks for a
DELETE
key press and runs BIOS Setup
if the key has been pressed.
Enabled The BIOS does not test system memory above 1 MB. The BIOS does not wait
up to 40 seconds for a READY signal from the IDE hard disk drive. If a
READY signal is not received immediately from the IDE drive, The BIOS does
not configure that drive. The BIOS does not wait for 0.5 seconds after sending
a RESET signal to the IDE drive to allow the IDE drive time to get ready again.
You cannot run BIOS Setup at system boot, because there is no delay for the
Hit <Del> to run Setup
message.
The Optimal and Fail-Safe settings are Disabled.