Intergraph ExtremeZ GL1, Настройка системы

Страница: 16 / 110

2
Unpacking the System
CAUTION Carefully remove items from packaging. Do not drop any items on a hard surface, or
damage may result. You may need a helper to assist you in removing and placing heavy
items.
Remove everything from the shipping cartons, then look for the following items:
u
A monitor with video cable, power cord, and documentation (if purchased from
Intergraph Computer Systems)
u
Workstation and power cord
u
Keyboard and mouse
u
Intergraph Computer Systems documentation
u
Windows NT Workstation 4.0 or Windows 95 operating system software (CD-ROM and
diskettes) and documentation
NOTE If any of these items were not delivered, call the Customer Response Center immediately at
1-800-633-7248.
Save the packaging materials. If you need to return equipment for repair, it must be in its
original packaging for you to get warranty service.
If you have already unpacked and connected the peripherals to the system, review the rest of
this chapter and then go to Chapter 2 to begin software setup.
Placing System Components
CAUTION Do not use the bottom portion of the face panel or the lip at the top rear of the unit as a hand
hold when moving the system. Equipment damage and personal injury can result.
When placing the system’s components, remember these guidelines:
u
Move and place the base unit and monitor carefully.
u
Place the base unit in a location where air can circulate freely around it. The front and
back panels should each have at least a 3-inch clearance.
u
Avoid exposing the system to high levels of dust, smoke, or moisture.
u
Maintain a temperature range of 10
°
C to 26
°
C (50
°
F to 80
°
F); the optimum
operating temperature is 21
°
C (70
°
F).
u
Maintain a humidity range from 20 percent to 80 percent (non-condensing); the
optimum humidity level is 50 percent.