Intellinet 523868, Руководство пользователя

Страница: 9 / 56

2.1.1 Configuration Using the Console Port (RS-232)
Prior to accessing the switch’s onboard agent (software that supports SNMP — see subsection
2.1.3 below) via a network connection, first configure the switch by giving it a valid IP address,
subnet mask and default gateway using an out-of-band connection or the BooTP protocol.
After configuring the switch’s IP parameters, you can access the onboard configuration program
from anywhere in the attached network or via the Internet by using Telnet from any computer
attached to the network or by using a Web browser (Internet Explorer 4.0 or above or Netscape
Navigator 4.0 or above).
Access the switch via a terminal emulator (such as HyperTerminal) attached to the console port.
The console port is set at the factory with the following default CoM port properties:
• Baud rate: 38,400
• data size: 8 bits
• Parity: None
• Stop bits: 1
• Flow Control: None
NOTE: Configure your own terminal to match these settings; otherwise, the connection will not
work.
2.1.1.1 Using HyperTerminal to Set the IP Address
1. Verify that a console cable (RJ-45 to dB9 [for
the RS-232]) connection between the switch and
the workstation exists.
2. launch the terminal emulation program on the
remote workstation and power on the switch.
Confirm that the correct COM port is selected.
3. enter the correct parameters according to
the defaults presented above. Click “oK.”
9
SYSTEM OVERVIEW