Intellinet 523868, Руководство пользователя

Страница: 17 / 56

Routing Protocol: This is the routing protocol type of the route. If it’s “connected,” the destination
is on the local lAN segment connected to the interface.
Destination: The destination IP address will be masked to generate an IP range as the objective
IP addresses of packets to be routed.
Mask: This is the mask for generating a range of IP addresses.
Connected via: This is the IP address of the next router for routing to another network.
Interface: This is the interface or VlAN Id from which the packets are routed outside.
2.2.6 routing
Routing on the Config Menu presents Static Route, RIP, OSPF, Multicast Route and VRRP.
2.2.6.1 Static Route
This section is used to add a routing entry into the switch routing table. A routing entry added this
way will never be deleted by the system, hence the designation as “static.” The parameters below
must be input in order to configure a static route.
Destination: enter the destination of the IP address.
Netmask: enter the subnet mask of the destination for generating the IP range to be routed.
Gateway IP: Enter the gateway IP address of the next router the packets are to be sent to.
Metric: enter a metric value (1-15). The lower the metric value, the more preferred the route.
Click “Add” after entering a new static route. The newly added entry displays in the list window.
delete the selected route by clicking “Remove.” Routes that are added or removed will be stored
in the configuration file immediately.
2.2.6.2 RIP
This section is used to activate
the RIP routing protocol. When
RIP is turned on, the switch will
exchange routing information with
neighbor switches that are also
running RIP. Three subsections
present additional options: Basic,
Passive Interfaces and RIP
Version, the latter two being
accessible from the Basic screen,
as explained below.
17
WEb MANAgEMENT